Maxon PAC-9 Pure Analog Chorus

The first thing you'll notice when you step on the PAC-9 is a beefy, full-bodied chorusing that punches you directly in the chest - gone are the thin, hissy, sissified chorus tones of yesteryear, replaced instead by a full-frequency effect that simply sounds massive.

The PAC-9's circuit uses professional-grade IC's typically reserved for High-End Audio applications, providing audiophile performance in a compact stompbox format.

When compared to a standard chorus, the PAC-9's effect appears more dramatic and has more presence in a mix - this is due to the retention of low and low-mid frequencies that are typically chopped out by other boxes.

The PAC-9's LFO has an extended range that allows it to nail classic rotary speaker sounds with ease. In addition to standard Speed and Width controls, The PAC-9 also features two unique controls: The Pure switch boosts the delayed signal by 4 dB to create a more dramatic, tremolo-like chorus effect, while the Bright switch subtly scoops lows on the delayed signal for a more traditional chorusing sound.

Standard and inverted (90 degrees out of phase) outputs allow for mono, stereo, or inverted mono signal routing options.

The PAC-9's internal voltage-doubling circuitry provides maximum headroom to eliminate input distortion. The higher operating voltage also allows it to be used in an FX loop to place the chorus effect post-gain.

Features - Maxon PAC-9 Pure Analog Chorus

• Analog chorus with lush, organic tone
• Wide-range Speed control for Rotary speaker effects
• Special noise filtering circuit
• Bright and Pure switches for additional tonal options
• Stereo outputs
• Works in FX loop or front-end of amp
• True Bypass Switching

Specifications - Maxon PAC-9 Pure Analog Chorus

NOTE ON POWERING THE PAC-9 - this pedal's voltage regulator IC requires a high inrush current of approximately 2000 mA upon startup. When using with a Power Brick such as the Voodoo Labs Pedal Power 2+, this pedal should be connected to a high current power jack when possible.

If it is not possible to connect to a high current jack, you can power the PAC-9 by leaving a battery in the pedal. Upon initial start-up, unplug the external DC power input cable, engage the pedal, and then plug the DC power input cable back in - the pedal will now power up normally off the external power supply until you power down your pedalboard.

• Input Impedance: 500K Ohms
• Output Impedance: 10K Ohms or less
• Maximum Output Level: +9 dB (400 Hz)
• Delay Time: 4.6 msec - 7.68 msec
• Speed Frequency: .33 Hz - 8 Hz
• Controls: SPEED, WIDTH
• Switch:
  • BYPASS/EFFECT (mechanical TBS)
  • PURE, BRIGHT
• In/Out: INPUT, OUTPUT, INVERSE OUTPUT
• Residual Noise: -95 dB (IHF-A)
• Indicator: BYPASS/EFFECT LED
• Internal Circuit Voltage: 9 VDC (DC-DC Converter)
• Current Consumption: 21 mA / 9 VDC
• Power Supply: 6F22 9V battery or Maxon AC Adaptor
• Battery Life:
  • Manganese battery 8.5 hours @ 25deg C
  • Alkaline battery 20 hours @ 25deg C
• Dimensions: 74 mm (W) x 124 mm (D) x 54 mm (H) / 2.9" (W) x 4.9" (D) x 2.13" (H)
• Weight: 580 g (including battery) / 20.46 oz.